The front end feels harsh, or the bike keeps bouncing after a bump. Before you change anything, it helps to know what the parts are and what each one does.
What the parts are
A suspension unit lets the wheel move up and down while the frame stays steadier. On an e-bike that means a fork at the front, a shock at the back, or both. A bike with neither is called rigid1.
Each unit has two jobs, done by two parts.2 says a spring and a damper are the two main components inside a fork or rear shock.
- The spring takes the hit. It can be a steel or titanium coil, compressed air, or an elastomer, which is a rubber-like block1.
- The damper controls the speed. Most dampers push oil through small holes2.
You need both. A spring alone would keep pushing back out, which is why the damper is there. That return movement has a name, rebound, and the page on damping terms covers it.
Where the spring and damper sit
On many forks they're split between the two legs. Wikipedia says the spring mechanism is often housed in one of the fork's legs and the damper in the other1. So a dial on one leg and a valve on the other isn't unusual.
Front, rear or both
A bike with only front suspension is called a hardtail. One with suspension at both ends is a dual or full suspension bike1.
Which one you own decides what there is to look after. A hardtail has a fork. A full suspension bike has a fork and a shock, plus the pivots between them.
Where to find them on your bike
Start at the front wheel. A suspension fork has tubes that slide inside other tubes. The fixed upper tubes hold the lower legs, which carry the wheel.
At the back, a shock is a short cylinder between the frame and the moving rear section, if your frame has one. No shock and no pivots usually means a rigid rear.
If you're not sure what your bike has, look in its manual or on the maker's product page for the spec list.
Why it matters for care
Seals, oil and air pressure all sit inside these parts. A fork that feels sticky points toward seals and oil. A fork that feels too soft or too firm points toward the spring or its settings. Those questions have their own pages:
- Spring types: Air springs versus coil springs
- How far it sinks at rest: What sag means
- The dials: Damping, rebound and lockout terms
- Movement range: Suspension travel
- Upkeep: Service intervals and Seals and oil
Where the numbers live
Forks and shocks come from specialist makers. The label on yours, or your bike's manual, tells you which one built it. That maker's manual is the document with pressures, settings and service steps for your exact model.
Pages here explain the ideas. Your manual has the numbers, and it's the one to follow.
Where the facts come from
- Bicycle suspension, Wikipedia
- How to set the SAG on your E-MTB Suspension in ten Minutes, E-MOUNTAINBIKE Magazine